VANCHOR™

It takes one person about 3 hours to fully install VANCHOR™. You will need a simple DEWALT battery powered drill (or similar drill) and all other  Tools and Hardware are included. Install your Plus Nuts with the included Tool and VANCHOR nut plates (approx. 1.5 hours) (one person) Bolt VANCHOR to the nuts with the Allen wrench (approx. 1.5 hours) (Can be done with one person, but two people is easier) Put your end caps on (15 minutes) No trips to home depot. You're ready [See More Photos]

Yes! Our VANCHOR™ DIY Attachment System provides a superior mounting system for your own home-built cabinets or just about any components you can think of!

While you might be able to fabricate your own mounting system for our cabinets and components, the VANCHOR™ DIY Attachment System is designed to make our component installations a breeze and will ensure that everything fits your Promaster well.

The VANCHOR™ DIY Attachment System includes: 5 rails for the driver's side wall 3 rails for the passenger side wall endcaps for each end 10ft of VANCHOR cover, to cover up any exposed rail All mounting hardware Once installed, you're ready for cabinets

Most of the tools to install the VANCHOR™ DIY Attachment System are included with the kit and include a Plus Nut Tool, Allen Wrench, and a rubber mallet. You will need a battery powered drill, such as the  DEWALT 20-volt Max 1/2-in Keyless Brushless Cordless Drill. They can be found at most hardware stores for around $99.00.

VANCHOR™ DIY Attachment System is pre cut, pre machined to fit your Promaster. You simply line it up with the ProMaster factory ribs and factory holes. No guesswork No frustration No mistakes